WATER IN DRUM BEFORE START OF PROG FUNCTIONS DISABLED UNTIL LEVEL IS BELOW SAFETY LEVEL

WATER LEVEL ALARM, REQUIRED LEVEL WAS NOT REACHED WITHIN 5 MINS (ALARM WILL STOP WHEN THE REQUIRED LEVEL HAS BEEN REACHED)

DRAIN ALARM WATER HAS FAILED TO DRAIN BELOW SAFETY LEVEL AFTER 1 MINUTE CYCLE WILL RESUMED ONCE LEVEL IS BELOW SAFETY LEVEL

HEATING ALARM TEMP HAS NOT RISEN BY AT LEAST 5C IN 20MINS, ALARM WILL STOP WHEN CORRECT TEMP IS ESTABLISHED

OVERTEMPERATURE ALARM, DISCONNECTED TEMP PROBE WATER TEMP HAS EXCEEDED 95oC CYCLE ABORTED

DOOR LOCK ALARM 10 SEC,S AFTER CYCLE START DOOR HAS FAILED TO LOCK, WASH CYCLE IS ABORTED

DOOR ALARM ,DOOR DAMAGED DURING CYCLE, CYCLE ABORTED

LEVEL ALARM WATER LEVEL 10CM ABOVE SET LEVEL CYCLE ABORTED

WATER IN DRUM AFTER SPINNING MOTOR WILL BE DISENERGISED FOR 90 SEC,S THEN A DISTRIBUTION STEP FOR 90 SEC,S TO REMOVE WATER E9 WILL BLINK DURING,THE ABOVE WILL BE ATTEMPTED UPTO 15 TIMES

MOTOR OVERLOAD CUT OUT THE CYCLE WILL BE ABORTED

TO RESET PRESS (-) KEY FOR 5 SEC,S WITH THE DOOR CLOSED,CYCLES ARE DISPLAYED, WITHIN 10 SEC,S PRESS (-) KEY TO RESET (REMOVE OFF PCB IF KEYPAD IS NONE RESPONSIVE)